Back
Exit to main menu
Settings
General
General device settings
Network
Basic settings of the network interface
Alarm limits
Configuration of the alarm limits
Measuring
Units, display settings, etc.
SOAP protocol
Setup SOAP protocol for database system
Email
Alarm emails configuration
Protocols
Syslog and ModbusTCP protocol settings
SNMP
SNMPv1 protocol and SNMP Traps
Time
Synchronization with NTP server
WWW and Security
Web server and Security configuration
MinMax memory
Timestamps, clear memory
Maintenance
Factory defaults, info, etc.
Measuring
Warning!
Configuration on this page cannot be saved. Jumper inside device is not closed. Please close jumper and refresh this page.
Display
Display can be configured to show required values. This fields control only LCD of the device. This setting does not affect to values shown on web pages.
LCD enabled
Show Temperature
Show Relative humidity
Show Computed value
Show CO
2
concentration
Show Atmospheric pressure
Units
Device measures values according selected physical units. History graphs and tables will be cleared after changing units.
Temperature Unit
°C
°F
Computed value
Dew point
Absolute humidity
Specific humidity
Mixing proportion
Specific enthalpy
Atmospheric pressure Unit
hPa
PSI
inHg
mBar
oz/in
2
mmHg
inH
2
O
kPa
Other settings
Compensation of measured values and other settings. For more information read the user guide carefully.
Pressure value for computed values
[hPa]
Atmospheric pressure offset
[hPa]
CO
2
RGB LED enabled
Yellow LED limit
[ppm]
Red LED limit
[ppm]
Average CO
2
measuring mode
Altitude for CO
2
compensation
[m]